Ok, so it looks like I'll be able to squeeze a pair of Image Dynamics 10's into this truck, so they'll each be dual 2 ohms in parallel (hence two 1 ohm loads)
Then I plan to wire these loads in series for a 2 ohm load. Each sub requires 250W RMS.
I'm looking for suggestions for Class D Mono amps that'll do about 250W @ 2 ohms - and which have as small of a footprint as possible!
Any suggestions much appreciated.....
Replies (1)
ttocs on 10/13/2003 21:57:23
memphis makes very small amps that put out good pwr. I have done a few and been impressed with them. JL, and PG are some other good ones as long as you are not on a budget...
Then I plan to wire these loads in series for a 2 ohm load. Each sub requires 250W RMS.
I'm looking for suggestions for Class D Mono amps that'll do about 250W @ 2 ohms - and which have as small of a footprint as possible!
Any suggestions much appreciated.....
Replies (1)
ttocs on 10/13/2003 21:57:23
memphis makes very small amps that put out good pwr. I have done a few and been impressed with them. JL, and PG are some other good ones as long as you are not on a budget...
Copyright ClubKnowledge 2009 * All Rights Reserved
