How do you wire a cut harness from factory radio on a 2000 honda civic to a new sony radio wire harness?
Replies (2)
goingcrazy on 12/17/2008 19:23:32
2000 honda civciv dx 2 door
swez on 12/17/2008 20:12:18
This is not good for a novice to deal with. However, one of our Golds addresses the steps in the following DIY link:
http://www.clubknowledge.com/Car_Audio_FAQ/?t36
Print a copy, study the steps and if possible, grab a buddy who knows a lot about mobile audio installs and has all the proper diagnostic tools at hand. A blind partner will only caused you to stumble too.
Forget the Orange ILL wire for the dash too. Most Aftermarket HU's have menu lighting presets. (Now you have 9 wires out of the way) That just leaves the following:
Red => ACC/IGN connection
Yellow => +12 volt constant for station Memory and Clock
Black => ground (do not use factory harness ground, make your own ground connection to floorpan, firewall or inside metal brackets in the HU install pocket)
Blue => If you have a power antenna
Good luck and be patient as you go,
Swez
PS I may have found the solution to your wiring needs. The lower diagram might match your car. There is a typo here. The would be pin M. Your HU will be solid green for the + Left/rear speaker:
http://www.installdr.com/Harnesses/HA-Wiring.pdf
Replies (2)
goingcrazy on 12/17/2008 19:23:32
2000 honda civciv dx 2 door
swez on 12/17/2008 20:12:18
This is not good for a novice to deal with. However, one of our Golds addresses the steps in the following DIY link:
http://www.clubknowledge.com/Car_Audio_FAQ/?t36
Print a copy, study the steps and if possible, grab a buddy who knows a lot about mobile audio installs and has all the proper diagnostic tools at hand. A blind partner will only caused you to stumble too.
Forget the Orange ILL wire for the dash too. Most Aftermarket HU's have menu lighting presets. (Now you have 9 wires out of the way) That just leaves the following:
Red => ACC/IGN connection
Yellow => +12 volt constant for station Memory and Clock
Black => ground (do not use factory harness ground, make your own ground connection to floorpan, firewall or inside metal brackets in the HU install pocket)
Blue => If you have a power antenna
Good luck and be patient as you go,
Swez
PS I may have found the solution to your wiring needs. The lower diagram might match your car. There is a typo here. The would be pin M. Your HU will be solid green for the + Left/rear speaker:
http://www.installdr.com/Harnesses/HA-Wiring.pdf
Copyright ClubKnowledge 2009 * All Rights Reserved
