|
Prev :: Next
whats up world i needed to know if i can hook up my (4) 6/12 sony explodes 2-way 2 my amp i have running my aw1200eu audiobahn subs and if i can how do i wire up please explain thanks youre help is appreshated. Replies (1) swez on 06/1/2008 07:02:44 This is pretty straight forward and no special tricks are needed here. In this case, one Sony Component speaker per channel is all that is needed. You'll need to wire each channel to the crossover's input lugs. (Observe polarity carefully) Then, wire the tweeter and midrange speakers to the output side of the crossover. Repeat this step until all speakers and crossovers are connected and then set the HPF's @ 80 Hz and gains to fill in the mix. It would be best to use a separate amp for your subs. However, if you wish to power the subs off this amp too, use the front channels of the amp to power the front speakers. The rear speakers can be powered off the HU amplifiers. (Rear channel only) Then wire the subs to channels 3 & 4 in bridged mode and use the LPF set @ 80 Hz. Adjust the rear channel gain as needed, but keep the bass clean and distortion free. Got all that? Swez Copyright ClubKnowledge 2009 * All Rights Reserved |