Hi everyone and anyone who can help me!
I am lookin to install two 12'' subs in my boot (i have found two i am interseted in) and two 6x9 sony speakers on my parcel shelf but i dont want to do this yet without a propper opinion on what size of amp i need to power all of this!?!?
SUB INFO
*JBL
*12" Car Audio Subwoofer
*Power Handling: 275W RMS, 1100W Peak
*Sensitivity: 93dB (2.83V, 1m)
*Frequency Response: 23Hz - 450Hz
*Impedence: 4 ohms
*£40
OTHER SUB
*Infinity
*1250W 12" subwoofer
*Dual stacked magnets
*300w RMS / 1000w peak
*£45
6x9 INFO
* 6" x 9" 3-way speakers
* Peak Power 300Watts
* Rated Power 60Watts
* Frequency response: 25Hz-27,000Hz
* Sensitivity: 93dB
* Ferrite HOP Cone Woofer
* £35 for the two
Am not tryin to sell anything here but if you want to know where i am getting them i have found this site www.bassjunkies.com
P.S Would i need anythin else to stop my battery from draining so quickly my mates said it would!
Thanks alot!
Replies (6)
newB on 03/6/2008 16:31:01
those subwoofers are single 4ohm, so your going to want an amp that does about 600watts rms @2ohm
JBL and infinity are both good solid budget woofers that are efficient and if treated properly will last a long time.
IF you want to amp the 6b9s a small 2ch class A/B amp will work fine. some larger questions to look into- what other speakers are you running other that the 6b9s? if so do you want them amped as well? do you want Loudness (spl) or a Quality Tone? (SQ)
with 6-7 hundred watts of power you can easily support this system with a good deep cycle battery under the hood and a quality "Big 3" upgrade
-Drew
Joe1990 on 03/6/2008 17:57:45
Thanks very much Drew
The only other speakers i am goin to run are the four already installed in my car 5.25'' but i think i might disconnect the back two if i have 6x9s in the back. Not sure weather to buy some quilty ones and if i did i would want to amp them aswell. I am lookin for Loundness (slp).
Another question what am i lookin for in an amp kit am not sure on what AWG (not even sure what it means am all new to this!) etc!
Thanks again
Joe
Joe1990 on 03/6/2008 18:07:09
Would this be more than enough? i really want to get it right for the good sound quality and last long! Thanks
Toxic TX-1600N 1600 watt 4 channel amplifier
MOS-FET PWM Power Switching Supply with Softstart
adjustable High-Pass 40 Hz - 240 Hz
adjustable Low-Pass 40 Hz - 240 Hz
Bass-Boost 0,6,12dB switchable
Line Out
Specification
Max. Output Power: 4 x 400W
Max Bridged Output Power: 2 x 800W
Highpass: 40Hz - 250Hz
Lowpass: 40Hz - 250Hz
Frequency Range: 10Hz - 40KHz
S/N Ratio: 100dB
Dimensions: 420x57x308mm
Damping Factor: 180
Thanks
newB on 03/6/2008 19:04:55
two options i can foresee here, ditch the rear fill 4"s and replace them with the 6b9s and amp all four speakers, or add the 6b9s AND another component set in the front and run 8speakers off a 4ch amp. if you want just pure loud then this is an option. the downside to running this is 1) your going to lose your imaging and SQ control will drop 2)you have to have an amp that will push 8 speakers instead.
what is your budget (in $ preferably) for the Amp(s) and speakers?
also, what car is it going into?
-Drew
Victor on 03/7/2008 00:18:15
that is a toxic amp.... those 400watts or 1600watts is the max power.
for real this amp should produce something around 75wrms x 4 @ 4 ohms ....
newB, you may want to revise your reply....
newB on 03/7/2008 00:36:27
you are correct ;-)
-Drew
I am lookin to install two 12'' subs in my boot (i have found two i am interseted in) and two 6x9 sony speakers on my parcel shelf but i dont want to do this yet without a propper opinion on what size of amp i need to power all of this!?!?
SUB INFO
*JBL
*12" Car Audio Subwoofer
*Power Handling: 275W RMS, 1100W Peak
*Sensitivity: 93dB (2.83V, 1m)
*Frequency Response: 23Hz - 450Hz
*Impedence: 4 ohms
*£40
OTHER SUB
*Infinity
*1250W 12" subwoofer
*Dual stacked magnets
*300w RMS / 1000w peak
*£45
6x9 INFO
* 6" x 9" 3-way speakers
* Peak Power 300Watts
* Rated Power 60Watts
* Frequency response: 25Hz-27,000Hz
* Sensitivity: 93dB
* Ferrite HOP Cone Woofer
* £35 for the two
Am not tryin to sell anything here but if you want to know where i am getting them i have found this site www.bassjunkies.com
P.S Would i need anythin else to stop my battery from draining so quickly my mates said it would!
Thanks alot!
Replies (6)
newB on 03/6/2008 16:31:01
those subwoofers are single 4ohm, so your going to want an amp that does about 600watts rms @2ohm
JBL and infinity are both good solid budget woofers that are efficient and if treated properly will last a long time.
IF you want to amp the 6b9s a small 2ch class A/B amp will work fine. some larger questions to look into- what other speakers are you running other that the 6b9s? if so do you want them amped as well? do you want Loudness (spl) or a Quality Tone? (SQ)
with 6-7 hundred watts of power you can easily support this system with a good deep cycle battery under the hood and a quality "Big 3" upgrade
-Drew
Joe1990 on 03/6/2008 17:57:45
Thanks very much Drew
The only other speakers i am goin to run are the four already installed in my car 5.25'' but i think i might disconnect the back two if i have 6x9s in the back. Not sure weather to buy some quilty ones and if i did i would want to amp them aswell. I am lookin for Loundness (slp).
Another question what am i lookin for in an amp kit am not sure on what AWG (not even sure what it means am all new to this!) etc!
Thanks again
Joe
Joe1990 on 03/6/2008 18:07:09
Would this be more than enough? i really want to get it right for the good sound quality and last long! Thanks
Toxic TX-1600N 1600 watt 4 channel amplifier
MOS-FET PWM Power Switching Supply with Softstart
adjustable High-Pass 40 Hz - 240 Hz
adjustable Low-Pass 40 Hz - 240 Hz
Bass-Boost 0,6,12dB switchable
Line Out
Specification
Max. Output Power: 4 x 400W
Max Bridged Output Power: 2 x 800W
Highpass: 40Hz - 250Hz
Lowpass: 40Hz - 250Hz
Frequency Range: 10Hz - 40KHz
S/N Ratio: 100dB
Dimensions: 420x57x308mm
Damping Factor: 180
Thanks
newB on 03/6/2008 19:04:55
two options i can foresee here, ditch the rear fill 4"s and replace them with the 6b9s and amp all four speakers, or add the 6b9s AND another component set in the front and run 8speakers off a 4ch amp. if you want just pure loud then this is an option. the downside to running this is 1) your going to lose your imaging and SQ control will drop 2)you have to have an amp that will push 8 speakers instead.
what is your budget (in $ preferably) for the Amp(s) and speakers?
also, what car is it going into?
-Drew
Victor on 03/7/2008 00:18:15
that is a toxic amp.... those 400watts or 1600watts is the max power.
for real this amp should produce something around 75wrms x 4 @ 4 ohms ....
newB, you may want to revise your reply....
newB on 03/7/2008 00:36:27
you are correct ;-)
-Drew
Copyright ClubKnowledge 2009 * All Rights Reserved
