THE FETS 1-2-3-4 ( IRF540)
5-6-7-8 ( RFP70N06 ) SUSTITUTE THE ORIGINAL ( 5N06 )
9-10-11-12 ( IRF540 )
THE RESISTANCE R11 200 OHMS
R121 200 OHMS
Replies (3)
swez on 02/2/2008 16:08:38
Are you sure you are at the right forum for this info?
Have not seen an Adrian on this site before and your details look more like a Power Mos IC component list for some device we normally do not address here. (N-Channel IC used in DC-DC power converters, switching mode power supplies) ???
If you are into electronic repairs for car audio products, feel free to hang around.
Swez
JESUSZAZ on 02/2/2008 16:45:37
SCUSE ME SWEZ, I ASWERED TO ADRIAN BUT I NOT PUT IT ANTENTION THE DATE OF CUESTION,. I HAVE A MTX 1502 BLUE THUNDER PRO AMP AND I NEED THE VALUES OF RESISTENCES R-118, R-89, R-115.
THANK YOU SWEZ
JESUSZAZ
swez on 02/2/2008 19:51:52
Hum, Mitek has a pretty good Tech Service support group for these types of issues. They would be your best source as they designed the circuits and make the amp in question.
Here, you'll want to speak to an Amplifier Design Engineer and get their inputs on the proper resistors/tolerances in question and the best IC fit as a replacement.
1.800. 225. 5689 - MTX Customer Service & Amplifier Service Center
Good luck,
Swez
5-6-7-8 ( RFP70N06 ) SUSTITUTE THE ORIGINAL ( 5N06 )
9-10-11-12 ( IRF540 )
THE RESISTANCE R11 200 OHMS
R121 200 OHMS
Replies (3)
swez on 02/2/2008 16:08:38
Are you sure you are at the right forum for this info?
Have not seen an Adrian on this site before and your details look more like a Power Mos IC component list for some device we normally do not address here. (N-Channel IC used in DC-DC power converters, switching mode power supplies) ???
If you are into electronic repairs for car audio products, feel free to hang around.
Swez
JESUSZAZ on 02/2/2008 16:45:37
SCUSE ME SWEZ, I ASWERED TO ADRIAN BUT I NOT PUT IT ANTENTION THE DATE OF CUESTION,. I HAVE A MTX 1502 BLUE THUNDER PRO AMP AND I NEED THE VALUES OF RESISTENCES R-118, R-89, R-115.
THANK YOU SWEZ
JESUSZAZ
swez on 02/2/2008 19:51:52
Hum, Mitek has a pretty good Tech Service support group for these types of issues. They would be your best source as they designed the circuits and make the amp in question.
Here, you'll want to speak to an Amplifier Design Engineer and get their inputs on the proper resistors/tolerances in question and the best IC fit as a replacement.
1.800. 225. 5689 - MTX Customer Service & Amplifier Service Center
Good luck,
Swez
Copyright ClubKnowledge 2009 * All Rights Reserved
