I just installed an amp in my truck and everything is hooked up except the speaker inputs. I am using the factory stereo so I don't have any RCA outputs. Also I don't have the wire harness for my amp. I have all four speakers running into the amp and the battery connection and power turn on are also hooked up. I just need is a way to connect the inputs. Any suggestions would be greatly appreciated.

Thanks

---

Replies (1)

---

Swez on 03/29/2003 15:41:40
There are these things called LOC's (Line out Convertors) that convert HU speaker outputs off the Stock HU, to RCA signal line levels. Then, you just run your RCA lines fro the LOC's t the amp RCA inputs.

Some of the better LOC's have trip pots to help balance HU voltage to amp input voltage needs. I recommend these.

Look here: http://www.scosche.com/scosche/electronic/SLC4.asp

You may be able to get these at Crutchfield or may have to shop around web or town for same. Circuit City and Best Buy usually carry similar devices... just avoid the cheapo jobs.

Swez

---