any ideas on running a conrtol wire to my amp because i've tried every wire in the back of factory HU and its hard to get to the wires in my fuse box
Replies (3)
cplkittle on 12/14/2006 21:37:25
I don't think there is a switched wire behind the radio, they use that crazy rap module to controll it..
you can get the acc wire in the ignition harness under the steering wheel, it is a 12ga, and you can use either the orange (accessory) or the brown (2nd accessory). This wire will come down the steering column and make a turn toward the drivers door.
ShootuhMcBustaCap on 12/14/2006 21:38:18
You will eitheir have to run a wire from a switched fuse in the the fuse box, run a wire from the battery to the amp, with an on and off switch wired inline, or you can do it the ghetto way, connect it to the batt+ on your amp, and pull the fuse every time. I have ran every setup except inline switch.
You don't actually have to acess the wires in the back of the fuse box, just wrap a wire around a blade of a switched fuse, and then reinsert the fuse. Put a 5 amp fuse in the wire to your amp to protect it from pulling too much current.
Any more questions?
ShootuhMcBustaCap on 12/14/2006 21:39:42
Go Kit! beat me to it by 45 sec, and offered a different better response than I had!! You Pimp!!
Replies (3)
cplkittle on 12/14/2006 21:37:25
I don't think there is a switched wire behind the radio, they use that crazy rap module to controll it..
you can get the acc wire in the ignition harness under the steering wheel, it is a 12ga, and you can use either the orange (accessory) or the brown (2nd accessory). This wire will come down the steering column and make a turn toward the drivers door.
ShootuhMcBustaCap on 12/14/2006 21:38:18
You will eitheir have to run a wire from a switched fuse in the the fuse box, run a wire from the battery to the amp, with an on and off switch wired inline, or you can do it the ghetto way, connect it to the batt+ on your amp, and pull the fuse every time. I have ran every setup except inline switch.
You don't actually have to acess the wires in the back of the fuse box, just wrap a wire around a blade of a switched fuse, and then reinsert the fuse. Put a 5 amp fuse in the wire to your amp to protect it from pulling too much current.
Any more questions?
ShootuhMcBustaCap on 12/14/2006 21:39:42
Go Kit! beat me to it by 45 sec, and offered a different better response than I had!! You Pimp!!
Copyright ClubKnowledge 2009 * All Rights Reserved
