I have a set of Infinity Kappa 652.5i coaxials and no where to mount them. I am going to build a sealed enclosure for them. How much air space should I allow?
Replies (1)
Ash on 06/22/2006 21:14:06
These are really designed for infinite baffle installs in factory locations. Though, there is no doubt an enclosure could get some or even better response from them; without some type of parameters to work with will make it a "blind shot in the dark".
What about kickpanels? This is not a bad option and will give the best imaging. Only con here is most prefabs are fit for 5.25". Perhaps some of the other guys will have some input.
Replies (1)
Ash on 06/22/2006 21:14:06
These are really designed for infinite baffle installs in factory locations. Though, there is no doubt an enclosure could get some or even better response from them; without some type of parameters to work with will make it a "blind shot in the dark".
What about kickpanels? This is not a bad option and will give the best imaging. Only con here is most prefabs are fit for 5.25". Perhaps some of the other guys will have some input.
Copyright ClubKnowledge 2009 * All Rights Reserved
