Well I finally got my amp back from the shop,been almost 3 months. They can't tell me why it falied again. They did not wan't to even tell me what was wrong but I finally got it out of them. They said it was the output mosfets were blown. Not sure what a mosfet is!! Am I thinking right that a output mosfet is the same thing as a output final??
Replies (2)
swez on 05/20/2005 18:46:36
You got it... same deal, and power output devices.... 10-4 good buddy!
These usually fry with too much heat due to ultra low ohmic load matching problems. (or a short)
Just curious, 3 months in the shop??? How much did they charge for parts and labor? Parts must have come from China huh?
Swez
alwaysbroke on 05/20/2005 19:55:44
not sure where they came from but it only cost me $36.00. I grounded the amp by it's self this time instead of with the other amp, my thinking is that maybe it was not a good enough ground !!
Replies (2)
swez on 05/20/2005 18:46:36
You got it... same deal, and power output devices.... 10-4 good buddy!
These usually fry with too much heat due to ultra low ohmic load matching problems. (or a short)
Just curious, 3 months in the shop??? How much did they charge for parts and labor? Parts must have come from China huh?
Swez
alwaysbroke on 05/20/2005 19:55:44
not sure where they came from but it only cost me $36.00. I grounded the amp by it's self this time instead of with the other amp, my thinking is that maybe it was not a good enough ground !!
Copyright ClubKnowledge 2009 * All Rights Reserved
