I have a 2002 Dodge Ram with a factory stereo (cassetted deck, cd changer, four speakers, not Infinity). I recently installed a Proflie AP1040 amp and a 12 inch JBL sub. I wired my four factory speakers through channels 1&2 on my amp, in parallel, and bridged channels 3&4 mono for the sub. I get from and rear fader control now and right and left balance control, but i'm only getting one channel into the sub not two...what do I do? where do I start troubleshooting?
Replies (1)
ttocs on 04/26/2005 14:20:06
only one sub plays, or only when you use the balence?
When you put an amp in mono often they use only one input. There may be a switch on there to combine the two, but there also may not be...
Replies (1)
ttocs on 04/26/2005 14:20:06
only one sub plays, or only when you use the balence?
When you put an amp in mono often they use only one input. There may be a switch on there to combine the two, but there also may not be...
Copyright ClubKnowledge 2009 * All Rights Reserved
