Have a 98 Toyota Camary. Recently had to replace the car battery. Now, I cannot get alarm out of valet mode. Alarm is an Ungo MS850. I have tried all suggestions in users manuel with no success. Any suggestions would be greatly appreciated.
Also, any advice on where to obtain a 2nd remote. Clarion charges $50.....quite expensive for an alarm that is several years old.
Thanks again
bdcooper
Replies (1)
Tray on 07/10/2003 08:34:10
OK, so what does it do when you attempt to get it out of Valet mode? Does it always chirp once to tell you it is in Valet mode?
Suggestions - check to make sure siren works. Disconnect valet switch, cycle power to unit, and then reconnect valet switch. Verify that valet switch is not stuck.
Remotes - I'd try ebay. (possibly look for a complete non-working alarm to use the parts from.)
Also, any advice on where to obtain a 2nd remote. Clarion charges $50.....quite expensive for an alarm that is several years old.
Thanks again
bdcooper
Replies (1)
Tray on 07/10/2003 08:34:10
OK, so what does it do when you attempt to get it out of Valet mode? Does it always chirp once to tell you it is in Valet mode?
Suggestions - check to make sure siren works. Disconnect valet switch, cycle power to unit, and then reconnect valet switch. Verify that valet switch is not stuck.
Remotes - I'd try ebay. (possibly look for a complete non-working alarm to use the parts from.)
Copyright ClubKnowledge 2009 * All Rights Reserved
