What is a better 4 channel amp, jbl 80x4 or the us acoustics 65 x 4? if you know about these amps (swez GRIN) any advice would help.
Thanks
Replies (1)
Swez on 07/4/2003 06:49:55
Well, I happen to like the USX-4065 for 4 channel applications and the JBL for sub amps.
Have been using a JBL sub amp for a few years now and it runs flawless... not a single hickup.
I did pick up a USX-4065 from a buddy and have yet to install it as I may be switching vehicles sooner than later. The guy I got it from upgraded to some very expensive SQ gear and I helped him design and fabricate a new sub enclosure... so he gave me some of his previous gear. Nice guy huh!
He did say that the USX was a very good amp... but he bumped up to DLS A4/A6 amps for his new install. Sweet install! He also had an MTX sub amp that really did not do the job... so he sold it cheap to a buddy. I believe, his major complaint was the amp overheated a lot at higher SPL levels.
Swez
Thanks
Replies (1)
Swez on 07/4/2003 06:49:55
Well, I happen to like the USX-4065 for 4 channel applications and the JBL for sub amps.
Have been using a JBL sub amp for a few years now and it runs flawless... not a single hickup.
I did pick up a USX-4065 from a buddy and have yet to install it as I may be switching vehicles sooner than later. The guy I got it from upgraded to some very expensive SQ gear and I helped him design and fabricate a new sub enclosure... so he gave me some of his previous gear. Nice guy huh!
He did say that the USX was a very good amp... but he bumped up to DLS A4/A6 amps for his new install. Sweet install! He also had an MTX sub amp that really did not do the job... so he sold it cheap to a buddy. I believe, his major complaint was the amp overheated a lot at higher SPL levels.
Swez
Copyright ClubKnowledge 2009 * All Rights Reserved
