Amp with 2 subs

by 2fastxd
  Prev :: Next
How would this amp be with 2 12" kv.2's

http://www.sonicelectronix.com/item_1995.html# USFLAG


Replies (6)
2fastxd on 11/30/2004 00:26:30
Thx

Munchiesyumm on 11/30/2004 01:21:16


Just looking at the spec's you get bad vibes. It's not very power efficent, not 1 ohm stable, 18dB boost (to cover up lack of power), it has only 50 amp max pull.

The question.. "will it run my subs" well yes of course.

But don't exspect superior sound quality or reliablility in hot weather or even long life time periods. This brand is no better than Boss, Pyle, or legency.

I wouldn't suggest this amp to anyone. There are more cost effective options that will allow benifits in all aspects. Sound, Power, Reliability, durability, you will find it easier on you're electricals with a highly efficient model.




Victor on 11/30/2004 02:40:06
I would never buy this amp if it were for me......

not a trustworthy brand... i wud say even the most notorious brand known for over rating amps : sony monobloc amps are far better than visonik, plye, boss, legacy, pyramid...etc

Well the other brands are far better than sony too.. alpine, jbl, jl, PG, MA, BA...etc....

If the signal and power going to Top Class subs is not good then even those subs wont play good.. you ought to be very careful while selecting amps .. especially when it is buying amps to power ur subs..

never go for cheap brands.. instead its always better to save money and not listen to good music in ur car for some time rather than listening to bad music thru out ur life..

comments...??

Victor...

2fastxd on 11/30/2004 07:46:57
ok, I found 2 more higher quality amps, which would be better for the 2 subs?

http://shop.store.yahoo.com/discountsonline/poaclt.html

http://www.onlinecarstereo.com/CarAudio/ProductReview.aspx?ProductID=13731

swez on 11/30/2004 08:37:51
That Power Acoustik amp has good potential. You can wire each sub at 2 ohms and 1 sub per channel. That's 360 WRms/sub. Not bad for such a low price.

One thing though, this amp will draw a few more amps than your car can deliver. Best guess, it will pull between 80-90A of current at full power. This is a Class A/B amp. So, efficiency of power usage is ~50-60%. It is bridgable to a 4 ohm load which your subs can do. However, best to look for Class D or T amps that can deliver solid power at 1 ohm loads.

I thought you were tracking the JBL BP-600.1 with the new subs? That amp is under rated (12.9 volts rating) at 600 RMS (almost 700 watts @ 13.5 volts) and is 1 ohm stable. That amp draws under 60A at full power and you will not hear a difference between the 2 amps.

Swez

2fastxd on 11/30/2004 15:44:29
yea but they ran out of stock thx



Prev :: Next
Copyright ClubKnowledge 2009 * All Rights Reserved

Valid HTML 4.01 Transitional