I'm moving my 10" sub from my old Dart to my spanky new 1988 Voyager. I'm having trouble finding a place to run the power cord through the firewall to get inside the van. The Dart has a really convenient rubber hole, but I can't seem to find anything in the Voyager.
I doubt installing subs in Voyagers is very popular, but does anyone happen to have any experience and know where the best place to run it is? Or any ideas where is a good place to look, or places to try?
Replies (1)
UKinstaller on 10/11/2004 19:13:30
well, i don't remember anything off the top of my head, however, check where any wiring harnesses or anything like that run through your firewall, if there is enough room to safely run the wire through there, that would be your best shot. if not, you will have to drill a hole. just find a spot inside the car that looks like there is enough room to drill comfortably, check the other side to make sure you aren't drilling into anything, and go at it. i usually start with a very small hole to make sure i am not hitting anything important. after the hole is drilled, stick a plastic grommet in there to make it pretty and avoid cutting the wire when running it through. if you bought a power kit, there should be a grommet with it. if not, go to a local shop and i'm sure somebody will give you one.
-UK
I doubt installing subs in Voyagers is very popular, but does anyone happen to have any experience and know where the best place to run it is? Or any ideas where is a good place to look, or places to try?
Replies (1)
UKinstaller on 10/11/2004 19:13:30
well, i don't remember anything off the top of my head, however, check where any wiring harnesses or anything like that run through your firewall, if there is enough room to safely run the wire through there, that would be your best shot. if not, you will have to drill a hole. just find a spot inside the car that looks like there is enough room to drill comfortably, check the other side to make sure you aren't drilling into anything, and go at it. i usually start with a very small hole to make sure i am not hitting anything important. after the hole is drilled, stick a plastic grommet in there to make it pretty and avoid cutting the wire when running it through. if you bought a power kit, there should be a grommet with it. if not, go to a local shop and i'm sure somebody will give you one.
-UK
Copyright ClubKnowledge 2009 * All Rights Reserved
