I'm trying to sell these things, i got 2 12s and a pioneer amp with about 400 rms 2 channel all 4 ohm and i got a problem, i tried hooking it up to bridge the amp and after about 10 seconds of playing the amp just shuts off, and seems like it resets itself or sumthing because it did the same a second time with on subs hooked up, also tried it with a different sub. and also i got a problem with them sounding crappy, they didnt seem to give me trouble before but what should i do, I made these homemade boxes not sure how big, how do u figure out cubic inch? and they seem they sound crappy when i turn it up, do I need more poly fill in the box, should i have a port tube in it or sealed, is my box too small its a little bigger than one for behind a regular cab seat, and there split boxes, or are they just crappy subs? THINK
Replies (1)
racerbizoehm on 06/26/2004 11:57:13
wait scratch that, I got it sounding better cuz the wires were backwards for some reason , always though red was positive, I'm wondering if I'm changing the ohms by bridging it? that would make the amp puting out 4 ohm to 2 separate channels then whats the bridged channel???
Replies (1)
racerbizoehm on 06/26/2004 11:57:13
wait scratch that, I got it sounding better cuz the wires were backwards for some reason , always though red was positive, I'm wondering if I'm changing the ohms by bridging it? that would make the amp puting out 4 ohm to 2 separate channels then whats the bridged channel???
Copyright ClubKnowledge 2009 * All Rights Reserved
