OK Gentlemen... You may recall you were most helpful helping me serlect the appropriate Amplifiers for my daughters car. Well I ended up ordering the PG Octane 8.0.4 and the PG Octane 5.0.1 sub amps. After getting sounddomain to price match both the total cost was only $400.50 for both, so I spent the little extra for two amps instead of the one 9.0.5 5-chanel amp. The AMPS are here and now I need to get the correct wire gauge and fuse to do the install.
Now with that said, the new question is what Power and Ground wire do you recommend? I am asking for recommendation on both brand and gauge. Based on your input I will not use a fused distribution block since the amps have them onboard. The 4-channel amp has two 30 amp fuses onboard and the sub amp has two 20 amp fuses onboard. I had read on Cruthfiled to simple add these together and insatll a fuse at the battery equal to the sum. In this case I was thinking a 100 watt ANL fuse. The Power and groud I was thinking should be either 2 or 4 gauge.
Will a 100 watt ANL fuse and 4 gauge wire do the job? Also, do you recommend a certain brand of fuse, fuse holder, distribution block and wire?
Also, would you recommend one power wire with a distribution block for the two amps or using separate power wires for each amp?
Replies (0)
Now with that said, the new question is what Power and Ground wire do you recommend? I am asking for recommendation on both brand and gauge. Based on your input I will not use a fused distribution block since the amps have them onboard. The 4-channel amp has two 30 amp fuses onboard and the sub amp has two 20 amp fuses onboard. I had read on Cruthfiled to simple add these together and insatll a fuse at the battery equal to the sum. In this case I was thinking a 100 watt ANL fuse. The Power and groud I was thinking should be either 2 or 4 gauge.
Will a 100 watt ANL fuse and 4 gauge wire do the job? Also, do you recommend a certain brand of fuse, fuse holder, distribution block and wire?
Also, would you recommend one power wire with a distribution block for the two amps or using separate power wires for each amp?
Replies (0)
Copyright ClubKnowledge 2009 * All Rights Reserved
