Hey I was looking over the 99 dodge durango that im about to put an amp and subs in. I wanted to see if anyone new the easiest way to run the power cords to the back. Obviously i can go through the firewall gromit and along the kick pannel, but after the second row of seating, i don't knwo the best way. Either to unbolt the back seat and see if i can run it under the floor, or the side boads that run right down to the back door running pannel. If anyone has done a lot of durangos i just wanted to see the best way and if there are any tricks or tools i might need for clips that might hold the back panels on. Thank you.
Replies (3)
ttocs on 03/24/2004 19:22:19
it should not be a problem. where are you going to put the amp?
Bazaz on 03/26/2004 13:55:05
I am going to mount the amp on the back side of the 3rd seat, but i want to know the easiest way to run the cables, both the power and audio cables, in the back of the truck, and if i should bother pulling out the back seat.
ttocs on 03/28/2004 13:01:40
I never pull the seat. As for the cables I will not be much help to you unfortunatly. Normally find where I am going to run the pwr first, then just do the opposit for the signal...
Replies (3)
ttocs on 03/24/2004 19:22:19
it should not be a problem. where are you going to put the amp?
Bazaz on 03/26/2004 13:55:05
I am going to mount the amp on the back side of the 3rd seat, but i want to know the easiest way to run the cables, both the power and audio cables, in the back of the truck, and if i should bother pulling out the back seat.
ttocs on 03/28/2004 13:01:40
I never pull the seat. As for the cables I will not be much help to you unfortunatly. Normally find where I am going to run the pwr first, then just do the opposit for the signal...
Copyright ClubKnowledge 2009 * All Rights Reserved
